Difference between revisions of "Arduino Motion"

Revision as of 14:07, 14 March 2012

This page is about building machines and motion control with the Arduino.

Note: {{{1}}}

Check also the CNC Control page!

Dual H-Bridge Shield (2 DC Motors or 1 Bipolar Stepper) http://arduino.cc/en/Main/ArduinoMotorShieldR3
Dual H-Bridge Shield (2 DC Motors or 1 Bipolar Stepper) http://www.dfrobot.com/index.php?route=product/product&product_id=69
Dual DC Motor driver (H-Bridge, only for brusshed motors) http://www.dimensionengineering.com/Sabertooth2X12.htm
Multipurpose motor Shield (4 H-Bridges: 4 DC Motors or 2 Bipolar Steppers + Servos) http://www.ladyada.net/make/mshield/
6 MOSFET Shield (3 x 5V PWM + 3 x 12v PWM) http://www.sparkfun.com/products/10618
Stepper Controller (Based on the Allegro Chip) http://www.pololu.com/catalog/product/118
Stepper Controller (Based on the Allegro Chip) http://www.sparkfun.com/products/10267
All-in one (Arduino + H-Bridge + ...) http://www.dfrobot.com/index.php?route=product/product&product_id=56 (They sell it in Ro-Botica)

@@ Line 14: / Line 14: @@
 == Motor Controller Boards ==
-{{note|Here is a long note, which is sufficiently wordy to run onto a second line, which would normally cause it to wrap round the icon, but because we passed it as a parameter it keeps its left alignment straight.}}
 {{note}} Check also the [[CNC Control]] page!
 * Dual H-Bridge Shield (2 DC Motors or 1 Bipolar Stepper) http://arduino.cc/en/Main/ArduinoMotorShieldR3