Difference between revisions of "ShopBot"
From Fab Lab Bcn WIKI
(→Machine workflow) |
(→Change a toolpath tool) |
||
| Line 42: | Line 42: | ||
===Change a toolpath tool=== | ===Change a toolpath tool=== | ||
| − | Run command 72. The machine will leave its tool on its tool holder and will go to look for the new tool. Once the new tool is load the machine will move to the Z tool distance area in the toolpath. Connect the aligator grip to the tool head. The machine will go down and save the tool length. | + | Run command 72. The machine will leave its tool on its tool holder and will go to look for the new tool. Once the new tool is load the machine will move to the Z tool distance area in the toolpath. Connect the aligator grip to the tool head. The machine will go down and save the tool length. Done. |
| − | + | ||
==External Links== | ==External Links== | ||
*[http://shopbotwiki.com/ ShopBot wiki] | *[http://shopbotwiki.com/ ShopBot wiki] | ||
Revision as of 17:10, 15 October 2010
Contents
CAM
- 2D Pathworks
- 3D Pathworks 3D or Rhino CAM
MCS
- ShopBot 3
Tools
Machine workflow
- Turn on the machine
- Turn on the air compressor
- Turn on the computer
- Run ShopBot 3
- Set Z zero.
- Set XY zero
- Add a new tool in the toolpath. In case.
- Load the PathWorks file with the holding drillings.
- Run the file. Press Start.
- Hold the material on the holes using screws.
- Load the PathWorks file with your job.
- Check the toolpaths numbers are ok.
- Run the file. Press Start.
- Wait
- Done
- Clean the machine area. Vacuum Cleaner.
Important commands
Set Z zero
Run command C2. Put the metal plate under the machine head and connect the aligator grip to the tool head. Run Enter. The machine will go down and adjust its Z zero. Done.
Set XY zero
Run command C3. The machine will move. Wait. Done.
Change a toolpath tool
Run command 72. The machine will leave its tool on its tool holder and will go to look for the new tool. Once the new tool is load the machine will move to the Z tool distance area in the toolpath. Connect the aligator grip to the tool head. The machine will go down and save the tool length. Done.
