Difference between revisions of "End Effector Catalogue"
(→Vaccume end effector with single Suction cap) |
|||
| Line 49: | Line 49: | ||
| − | ''' | + | '''Required parts:''' |
| − | + | Vacuum Generator / Union / Square | |
| − | + | Suction Cup (coval VP15NBRIF18C) | |
| − | + | Pneumatic Push to Connect Fittings Male Straight | ∅ 8mm Tubing | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
==Health & Safety== | ==Health & Safety== | ||
Revision as of 17:14, 27 June 2023
Contents
Motor Screw Extruder
Arduino Diagram
Connection to robot
elements, power supply inlet plug with undervoltage release to prevent re-start in case of voltage interuption
3- Hopper for wet premixed material
4- Housing with polyurethan inlet
5- Worm pump
6- Pump outlet with pressure gauge
Operating the machine
Connections Before Start-Up
Connect the main power plug to the control cabinet with the cable to the construction 230V/1/N/PE/50Hz (3x1,5mm2).
Make sure that all cables and safety devices are functioning properly.
Vaccume end effector with single Suction cap
Required parts:
Vacuum Generator / Union / Square
Suction Cup (coval VP15NBRIF18C)
Pneumatic Push to Connect Fittings Male Straight | ∅ 8mm Tubing
Health & Safety
- Always use safety glass while disconnecting the hose.
- Never run the machine dry, at least water is needed to operate the pump otherwise damage may occur.
- Never let the material fall below the minimum material level and always keep the screw under the material.
- Never disconnect the hose when there is any pressure in the pressure gauge.
Machine Views
1- Motor
2- Control system: Frequency converter with switch elements, power supply inlet plug with undervoltage release to prevent re-start in case of voltage interuption
3- Hopper for wet premixed material
4- Housing with polyurethan inlet
5- Worm pump
6- Pump outlet with pressure gauge
Operating the machine
Connections Before Start-Up
Connect the main power plug to the control cabinet with the cable to the construction 230V/1/N/PE/50Hz (3x1,5mm2).
Make sure that all cables and safety devices are functioning properly.
Start-up in manual mode
- Before Operating the machine check the machine state. Switch rightwards for manual mode.
- Step 1: Turn on the main switch
- Step 2: Fill the material-hopper with wet premixed material.
- Step 3: Turn the Forward/Reverse Switch to FWD (Start the machine by turning the mode switch from 0 to FWD)
