Difference between revisions of "3D PRINTING WITH ROBOTS"

Revision as of 18:22, 30 January 2024

Material Preparation

Testing material viscosity and printability before 3D printing with a robot is indeed a prudent step to ensure successful printing outcomes. Here's a breakdown of the recommended process:

Manual Extrusion Test with a Closed Tube Mortar Gun:

- Use a closed tube mortar gun to manually extrude the material.

- This allows you to assess how the material flows and how it behaves during extrusion.

- The closed tube design helps in maintaining consistent pressure and control over the extrusion process.

Mixing the Material:

- Ensure thorough mixing of the material to achieve homogeneity.

- Inadequate mixing can result in inconsistencies in material properties, affecting print quality.

- Avoid adding excessive water content, as it can cause shrinkage issues during printing.

- Conversely, too little water content can lead to dry material, making it difficult to print.

Motor screw extruder

The Motor screw extruder was originally developed by Eduardo Chamorro Martin in collaboration with 3DPA IAAC. This innovative tool, which is open source, has since been further enhanced and modified by IAAC staff members for various applications.

For detailed information and updates on the Motor screw extruder, please visit the GitHub repository at the following link: https://github.com/EDUARDOCHAMORRO/FabricatableTools

Printing Steps

Step 1: Tool setup

- Ensure that all components of the extruder are properly assembled.

- Mount the End Effector with the Robot Flange securely. Use the appropriate screw size and ensure that the extended parts of the screws do not protrude on the rear side of the flange to prevent scratching or damaging the robot arm.

- Before loading the material into the cartridge, inspect it to ensure there are no air bubbles trapped inside. Air bubbles can disrupt the printing process and cause damage to the print quality.

- Apply vaseline to the piston and threads in the metal cap of the cartridge. This helps to ensure smooth movement and prevent friction during the printing process. Make sure the cap is tightly secured to avoid any leaks or inconsistencies in printing material flow.

- Release Pressure Using Pressure Regulator.

- Connect the air pressure pipe and the motor cable to the designated connector.

Step 2:TCP Calibration

- Calibrate the tool properly.

- For more details about calibration check the following document

https://drive.google.com/file/d/196kO1AxNpu0TbMAIdhFcR8AHWfLMZXfV/view

- Place the TCP value in the gh files

Step 3:Extrusion test

- Check Digital Outputs Utilize the flex pendant. Use programmable keys on the flex pendant to navigate through the settings and verify that all digital outputs are functioning correctly.

- Activate the motor and preassure, Gradually adjust the pressure regulator to raise the pressure. Monitor the extrusion process for consistency and quality.

Step 4:Base calibration

- Use masking or double-sided tape to prevent the base from moving.

- Jog the robot to three different positions. Add Coordinates to Grasshopper File for accurate geometry placement.

Step 5:Export and running the file

IMPORTANT:

Before running the main file, conduct a pressure-free dry run, execute the file slowly, verify the correctness of the z value, ensure the nozzle doesn't hit the base, and adjust the z value if needed.

- Check if the robot is in manual mode

- Acknowledge any errors seen on the flexpendant

- Export your file in .PRG format and copy it in a USB

- Plug in the USB in the port on the flexpendant

- FInd the USB folder and change it to old format (.PRG)

- Check the speed before running the file.

- Press the Guard stop and press the play button to initiate the file

Termination of work and cleaning