Difference between revisions of "Hitachi C8FSHE Slide Compound Miter Saw"
From Fab Lab Bcn WIKI
| Line 3: | Line 3: | ||
[[File:Hitachi-C8FSHE.png| thumb |Hitachi C8FSHE Slide Compound Miter Saw]] | [[File:Hitachi-C8FSHE.png| thumb |Hitachi C8FSHE Slide Compound Miter Saw]] | ||
| − | + | A miter saw is a saw used to make accurate crosscuts and miters in a workpiece by pulling a large backsaw or a mounted circular saw blade down onto a board in a quick motion.It is commonly used for cutting of molding, trim and small boards. | |
| + | |||
| + | The workpiece is held against a fence, which provides a precise cutting angle between the plane of the blade and the plane of the longest workpiece edge. In standard position, this angle is fixed at 90° | ||
| + | |||
| + | It's possible to move the base precise one-degree incremental changes or also provide "stops" that allow the miter index to be quickly set to common angles (such as 15°, 22.5°, 30°, and 45°) | ||
| + | |||
| + | ==Safety== | ||
| + | *Use always safety glasses | ||
| + | *Respect the safety distance limit between the hand and the blade, indicated on the machine | ||
| + | *if the piece of wood is too small, use another machine | ||
| + | *Let the blade come to a complete stop at the end of each cut before lifting it. | ||
==How to use== | ==How to use== | ||
Revision as of 16:44, 26 March 2020
A miter saw is a saw used to make accurate crosscuts and miters in a workpiece by pulling a large backsaw or a mounted circular saw blade down onto a board in a quick motion.It is commonly used for cutting of molding, trim and small boards.
The workpiece is held against a fence, which provides a precise cutting angle between the plane of the blade and the plane of the longest workpiece edge. In standard position, this angle is fixed at 90°
It's possible to move the base precise one-degree incremental changes or also provide "stops" that allow the miter index to be quickly set to common angles (such as 15°, 22.5°, 30°, and 45°)
Safety
- Use always safety glasses
- Respect the safety distance limit between the hand and the blade, indicated on the machine
- if the piece of wood is too small, use another machine
- Let the blade come to a complete stop at the end of each cut before lifting it.
How to use
- Push the wood against the metal bar.
- Make a line on the material where you want to cut.
- Put the blade on the side of the line (not in the centre)
- Start from far, go down and go forward.
- You can adjust two different angles. the angle of the base or the angle of the blade
- You can use the laser light to check for the line of cut.
External link
http://www.hitachi-koki.com/powertools/products/saw/c8fshe/c8fshe.html
