Difference between revisions of "Troteclaser"

Revision as of 16:27, 20 March 2015

Never leave the laser device unattended while the system is operating.
Always have a fire extinguisher available, as the laser beam can ignite flammable materials.
Do not put any flammanle materials in the inside of the device or in the immediate surroundings of the device.
Be aware of all Laser safety stickers on the machine and follow them.
The system must be used only by authorized and trained personnel.
Avoid electrostatic charging during cable connections / plug-in.
Do not start the Laser machine without an adequate exhaust system.
In case of a broken lens: avoid direct skin contact and inhaling.
"EMERGENCY-STOP": on any risk: LIFT THE COVER LID!

Check the scale of the drawing , make sure you are in millimeters and that your material fits in the laser.

Seldup command selects duplicate lines. Keep in mind that is there are more than one lines the laser cutter will pass more times over the same place.

Make2d if you import your drawing from other programs other than rhino and to make sure that everything is on 0 in Z plane.

	`12` Engrave Cut Cut Cut Cut Cut Cut Cut Cut Cut Cut Cut Cut Cut Cut

Do not touch directly the lens during the operation.
Pour on it a drop of the specific product : "Lens clens".
Clean it with the appropriate electrostatic tissues : "Edmund Industrial Optic".

@@ Line 30: / Line 30: @@
 |-valign="top"
 |[[File:4ColourSelection.jpg| 700 × 402 pixels]]
-|{{Grossir|<br>Engrave <br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut|facteur=1.5}}
+|<tt>12</tt><br>Engrave <br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut<br>Cut
 |}
 <br><br>