Difference between revisions of "Fab @ Home"
From Fab Lab Bcn WIKI
(→Setting up) |
|||
| (3 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
| − | [[Category:Machines]] | + | [[Category:Old Machines]] |
| − | == | + | == the [http://www.sproutseo.com seo services] Machine == |
===Materials=== | ===Materials=== | ||
| − | Here | + | Here are the instructions to use the Fab@Home for food printing. |
| + | |||
| + | Possible Material: | ||
Agar (commonly known as gelatin powder) | Agar (commonly known as gelatin powder) | ||
*melting point: > 90°C | *melting point: > 90°C | ||
*freezing point: < 40°C | *freezing point: < 40°C | ||
| − | |||
| − | |||
Chocolate | Chocolate | ||
| Line 17: | Line 17: | ||
Cheese | Cheese | ||
| + | |||
| + | Wasabi | ||
Corn Flour | Corn Flour | ||
===Setting up=== | ===Setting up=== | ||
| − | *5 cables should be connected between the snap hub and each of the motors | + | *Melted the edible materials for later use |
| + | *5 cables of the printer should be connected between the snap hub and each of the motors | ||
*1 USB cable is connected from the snap hub to the control computer | *1 USB cable is connected from the snap hub to the control computer | ||
*Check the movements of X, Y, Z, Bay 1 and Bay 2, if some of them doesn't run, it may be the problem of : | *Check the movements of X, Y, Z, Bay 1 and Bay 2, if some of them doesn't run, it may be the problem of : | ||
Latest revision as of 10:38, 28 April 2016
Contents
the seo services Machine
Materials
Here are the instructions to use the Fab@Home for food printing.
Possible Material:
Agar (commonly known as gelatin powder)
- melting point: > 90°C
- freezing point: < 40°C
Chocolate
- melting point: > 50°C
- freezing point: < 17°C
Cheese
Wasabi
Corn Flour
Setting up
- Melted the edible materials for later use
- 5 cables of the printer should be connected between the snap hub and each of the motors
- 1 USB cable is connected from the snap hub to the control computer
- Check the movements of X, Y, Z, Bay 1 and Bay 2, if some of them doesn't run, it may be the problem of :
- Bay, the screw inside the gear is loose
- XYZ axis, the belt is loose
- X axis, a small screw near the motor is loose
Software
File Format:
- Material file: .xml
- Image file: .stl or .amf
- FAB file: .fab
Step:
- Open .stl file in FabStudio v2.0.1,
- Click on the object to activate the property
- Edit the actual size and printing position
- Choose the material
- Save as .fab
Parameters of the printing can be changed directly in the files of .fab or .xml:
- pathSpeed
- pathWidth
- pushOut
- suckBack
- suckBackDelay
- sliceHeight (only available in .xml)
